New Irrigation Meter - Capping Old Line
-
- Posts: 17
- Joined: May 4th, 2015, 1:40 pm
- Location: Atlanta, Georgia
- Grass Type: Zenith Zoysia
- Lawn Size: Not Specified
- Level: Not Specified
New Irrigation Meter - Capping Old Line
http://postimg.cc/image/sywazhk19/
Long story short, Atlanta charges obscene water rates. I had an irrigation meter installed at the street and I want to tie it into my new system. I can do most of the work myself, but I was wondering about capping the old line that runs off my main inbound water line. I sketched out the current setup. Basically I just want to cut into the pvc line that runs to the first bib valve (my primary on/off valve for the system). Would it be that simple as cutting the line and gluing a pvc cap piece on?
Long story short, Atlanta charges obscene water rates. I had an irrigation meter installed at the street and I want to tie it into my new system. I can do most of the work myself, but I was wondering about capping the old line that runs off my main inbound water line. I sketched out the current setup. Basically I just want to cut into the pvc line that runs to the first bib valve (my primary on/off valve for the system). Would it be that simple as cutting the line and gluing a pvc cap piece on?
- andy10917
- Posts: 29741
- Joined: February 23rd, 2009, 10:48 pm
- Location: NY (Lower Hudson Valley)
- Grass Type: Emblem KBG (Front); Blueberry KBG Monostand (Back)
- Lawn Size: 1 acre-2 acre
- Level: Advanced
Re: New Irrigation Meter - Capping Old Line
How would you turn off the water to the spot where you want to cap the old line? Can you (or someone) turn it off at the street? If not, it's gonna get "real interesting" when your reciprocating saw cuts into the existing line.
-
- Posts: 17
- Joined: May 4th, 2015, 1:40 pm
- Location: Atlanta, Georgia
- Grass Type: Zenith Zoysia
- Lawn Size: Not Specified
- Level: Not Specified
Re: New Irrigation Meter - Capping Old Line
Yeah I can just turn it off at the street and drain the line.
- andy10917
- Posts: 29741
- Joined: February 23rd, 2009, 10:48 pm
- Location: NY (Lower Hudson Valley)
- Grass Type: Emblem KBG (Front); Blueberry KBG Monostand (Back)
- Lawn Size: 1 acre-2 acre
- Level: Advanced
Re: New Irrigation Meter - Capping Old Line
Assuming that it's all PVC, and you have the cleaning purple, the right glue and the right size cap, it should go smoothly then.
-
- Posts: 2692
- Joined: April 25th, 2014, 11:11 pm
- Location: Macomb County Michigan
- Grass Type: Front/Side - Emblem, Back - Panterra V
- Lawn Size: Not Specified
- Level: Not Specified
Re: New Irrigation Meter - Capping Old Line
I would also suggest you shut the valve off at the house, as well. There a lot of water in those pipes, in your house. It will keep the trench much drier.
Who is online
Users browsing this forum: No registered users and 5 guests