Page 1 of 1

Weed-killer choices while seeding bare spots with KBG

Posted: March 10th, 2020, 9:11 pm
by lawnlawn
Hello,
I am noticing weeds showing up everywhere in my newly established KBG lawn, attached are weed pictures. I want to kill these weeds and also want to seed bare spots in the next few days where grass either grew sparse or not at all.

I would really appreciate recommendations on the choice of weed killers while seeding bare and thin areas.

The only weed killer I have is Weed b gon that I bought during last Fall clearance.
Image

Image

Image

Re: Weed-killer choices while seeding bare spots with KBG

Posted: March 10th, 2020, 11:11 pm
by Green
There are not a lot of post herbicides that permit seeding KBG during use. The one that comes to mind is Tenacity. But even with it, you cannot apply it during the actual germination period. Before is fine.

As far as your product, check the label. It will give you a number of weeks to wait after use before dropping the seed.

Re: Weed-killer choices while seeding bare spots with KBG

Posted: March 11th, 2020, 8:27 am
by lawnlawn
Green wrote:
March 10th, 2020, 11:11 pm
There are not a lot of post herbicides that permit seeding KBG during use. The one that comes to mind is Tenacity. But even with it, you cannot apply it during the actual germination period. Before is fine.

As far as your product, check the label. It will give you a number of weeks to wait after use before dropping the seed.
Thanks.
So would it be wiser to ignore weeds for now and focus on seeding to thicken the lawn and fill bare spots?

Re: Weed-killer choices while seeding bare spots with KBG

Posted: March 11th, 2020, 11:18 am
by TimmyG
Broadleaf weeds will get large much faster than new grass seedlings, making it particularly difficult to grow new grass in the bare spots, so you want to do something about the weeds first. And then I suggest applying Tenacity to the bare soil at seed down for it's moderate performance as a pre-emergent. Either hand pull the weeds or apply an herbicide and wait the appropriate number of weeks before dropping seed...most important if you intend to broadcast spray. Precision spot spraying of weeds could afford you the opportunity to seed earlier if the weeds are sparse, but that's off label, so it's up to you assess the risk and your ability.

Re: Weed-killer choices while seeding bare spots with KBG

Posted: March 12th, 2020, 9:17 am
by lawnlawn
TimmyG wrote:
March 11th, 2020, 11:18 am
Broadleaf weeds will get large much faster than new grass seedlings, making it particularly difficult to grow new grass in the bare spots, so you want to do something about the weeds first. And then I suggest applying Tenacity to the bare soil at seed down for it's moderate performance as a pre-emergent. Either hand pull the weeds or apply an herbicide and wait the appropriate number of weeks before dropping seed...most important if you intend to broadcast spray. Precision spot spraying of weeds could afford you the opportunity to seed earlier if the weeds are sparse, but that's off label, so it's up to you assess the risk and your ability.
Thanks! So based on your advice plan is to attempt spot spraying with weed b gon and either pull out weeds by hand on bare spots or use glyphosate a day before seeding for bare spot areas. I have leftover Scotts starter fertilizer with Tenacity so I will use that during seeding, perhaps together with Milorganite as I did last fall.

Re: Weed-killer choices while seeding bare spots with KBG

Posted: March 12th, 2020, 10:14 am
by TimmyG
Sounds like a plan. Git 'er done.

FWIW, when I spot spray, I tend to keep the pressure in the sprayer a little low. Yes, droplet sizes get larger and the spray less uniform, but I can control what gets sprayed much better, especially if I'm spraying in a perennial or shrub bed. Alternatively, if you don't trust your accuracy, you can rig a cone over the spray tip to confine the spray. Again, borrow my ideas at your own risk. Whenever reasonable, I do prefer to hand pull.

Re: Weed-killer choices while seeding bare spots with KBG

Posted: March 13th, 2020, 9:01 am
by lawnlawn
TimmyG wrote:
March 12th, 2020, 10:14 am
Sounds like a plan. Git 'er done.

FWIW, when I spot spray, I tend to keep the pressure in the sprayer a little low. Yes, droplet sizes get larger and the spray less uniform, but I can control what gets sprayed much better, especially if I'm spraying in a perennial or shrub bed. Alternatively, if you don't trust your accuracy, you can rig a cone over the spray tip to confine the spray. Again, borrow my ideas at your own risk. Whenever reasonable, I do prefer to hand pull.
Thanks for all the tips :good: